Jump to content


Photo

Red Stars


  • Please log in to reply
45 replies to this topic

#31 Pyromaster2003

Pyromaster2003

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 479 posts

Posted 01 November 2003 - 07:21 PM

i made some red stars the other day with the 20:20:60/Sugar:Strontium Carbonate:KCLO3 formula. Took them 2 days you dry slightly. could have been to do with the almost non stop rain and cold weather though. so today being as impatient as i am, i through them on some tin foil and put in my gas oven on top shelf. the gas was on the lowest possible flame and the door was left 1 inch open. half an hour later, rock hard:). time for testing...held a flame to one of them and it took about 3-4 seconds and then it burst in the most beautiful red iv ever seen and burns for aaages. test fired in my 1 shot roman candle and after i got the lift charge right they would shoot up 20 feet burning bright red, unfortunatly they would fall back to earth still on fire for a good few seconds. and i tryed adding more BP lift (i know its risky with chlorate and sulphur from BP but its not scaring me away since iv hod no problem when shaking the chlorate stars in a small plastic cup of BP...) but the stars got blown to bits. so anyway, iv made a kind of shell which i will fire a bit later. the shell is 1 inch in diam, 5 cm long. got a lift charge on the bottom end with a fuse going into it then 7 stars on top of this then a card disk slipped down ontop of the stars. hopefully the shell will be lifted quite high then with eject the 7 stars with a 'fffft' and these will then fall about 10 feet an go out. im afraid my mortar is going to explode though, because the shell is fitted in very tightly because the nearer the bottom of the mortar there is loads of BP soot. added an extra long fuse and will have to take cover. wish me look ey :(

Edited by Pyromaster2003, 01 November 2003 - 07:33 PM.


#32 Pyromaster2003

Pyromaster2003

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 479 posts

Posted 01 November 2003 - 07:23 PM

sorry forgot to add link to a video of my red stars. these look totally amazing in flight. http://henryhallam.c...ost/redstar.WMV

#33 Matt

Matt

    Another Aussie Trying To take Over

  • General Public Members
  • PipPipPip
  • 396 posts

Posted 02 November 2003 - 01:32 AM

Your red stars make me angry.......
But its only a matter of time before I have my 25 kilos of perchlorate! Muahahahahahahahahahahahahaha.

-Matt
Try to run! try to hide! Break on through to the other side!! YYYEEEAAAAOOHHHHHHHHAAAAHHHHHHHH

#34 Stuart

Stuart

    BPS Member

  • General Public Members
  • PipPipPip
  • 664 posts

Posted 02 November 2003 - 07:40 AM

If the mortar tube is getting BP soot at the bottom, why not get a wire brush and clean it out. Or, better yet, for a faster job, put the wire brush on the end of a drill.

Stuart

#35 Pyromaster2003

Pyromaster2003

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 479 posts

Posted 02 November 2003 - 11:32 AM

hehe Matt:) should see wat they look like ina roman candle. infact saying that, il make a video tonight maybe with a star being fired from a tube.

i usualy do clean it out after use with tissue taped to a dowel slightly smaller than the ID of the mortar. it was a while before i used it and must have forgotten to clean after last use. anyway, it didnt explode which amazed me. i used 2.5 teaspoons of pulverone to fire the test shell and it fired up put came to pieces. what i had tryed first was to ram 2cm of clay into the tube and then drill a hole in for the fuse. i didnt have the right size rammer... :rolleyes: so then i used a plastic bottle cap with a hole in and fused up. i then used duct tape to secure this onto the bottom of the same OD tube. then put 1 teaspoon of pulverone in the bottom, added the 7 red stars and poured half a teaspoon of meal on top of them to help ignition (stars already coated in primer). but from what i could see, the bottle cap came off and the stars and pulverone spread all over. was a great shame. will have to find a good size dowel and try that one again. anyone got any adeas for securing the bottle cap to the shell tube? there is a space of 1-2mm all the way round the shell and bottle cap when there is no cellotape around it.

#36 lord_dranack

lord_dranack

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 251 posts

Posted 03 November 2003 - 12:01 PM

I tried the red formula you mentioned with lactose (there was no normal sugar in the house!)
It gave an incredable red, far better than my previous shellac based attempts

#37 Rhodri

Rhodri

    One of the gang!

  • General Public Members
  • PipPipPip
  • 486 posts

Posted 03 November 2003 - 12:06 PM

Hey Pyromaster - those red stars are EXCELLENT.

Will have to try some!

Well done!

Rhod

:)
Making light, sound and good conversation.

#38 Matt

Matt

    Another Aussie Trying To take Over

  • General Public Members
  • PipPipPip
  • 396 posts

Posted 03 November 2003 - 12:22 PM

Damn you all and your fancy schmancy colours! I dont need you! I dont even need your colours! *runs off crying*

-Matt
Try to run! try to hide! Break on through to the other side!! YYYEEEAAAAOOHHHHHHHHAAAAHHHHHHHH

#39 Jerronimo

Jerronimo

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 345 posts

Posted 03 November 2003 - 03:10 PM

Hey Pyromaster - those red stars are EXCELLENT.

Will have to try some!

Well done!

Rhod

:)

Hey Rhodi if you are looking for a blue star formula:

KCIO3 50 %
coppersulfate 25 %
sugar 25 %
"Any society that would give up a little liberty to gain a little security will deserve neither and lose both."

#40 Jerronimo

Jerronimo

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 345 posts

Posted 03 November 2003 - 03:12 PM

Hey Pyromaster - those red stars are EXCELLENT.

Will have to try some!

Well done!

Rhod

:)

Hey Rhodi if you are looking for a blue star formula:

KCIO3 50 %
coppersulfate 25 %
sugar 25 %
"Any society that would give up a little liberty to gain a little security will deserve neither and lose both."

#41 Pyromaster2003

Pyromaster2003

    Pyro Forum Regular

  • General Public Members
  • PipPipPip
  • 479 posts

Posted 03 November 2003 - 05:58 PM

yea thanks Rhodri, i think so too :D will have to experiment a bit though because they are weird to light :blink:

#42 Matt

Matt

    Another Aussie Trying To take Over

  • General Public Members
  • PipPipPip
  • 396 posts

Posted 03 November 2003 - 11:25 PM

The sugar wont keep very long i dont think. Probably need to be re-dried every week :rolleyes:

-Matt
Try to run! try to hide! Break on through to the other side!! YYYEEEAAAAOOHHHHHHHHAAAAHHHHHHHH

#43 leniol

leniol

    Member

  • General Public Members
  • PipPip
  • 37 posts

Posted 07 November 2003 - 02:32 PM

Sculpy (fimo) will work as a chlorine donor, just grate the undried stuff on a lemon zester or similar. Then again, the colours aren't as good as those sugar based stars. I wonder if you could bind with NC lacquer to waterproof them? I shall have to leave someone else to try as I'm stuck many miles away from home & have an essay on doctor's liabilites to disabled children to write... <_< :( :unsure:

#44 BigG

BigG

    Pyro Forum Top Trump

  • General Public Members
  • PipPipPipPip
  • 1,539 posts

Posted 07 November 2003 - 08:29 PM

Well, I would just drop out the sugar :) Honestly ? sugar makes very poor choice in compositions ? and very few formulations use them. Use other binders to much greater effect and they are also much more time resistant.

#45 Pazza

Pazza

    Not just a pretty face

  • General Public Members
  • PipPip
  • 57 posts

Posted 08 November 2003 - 10:54 AM

Hey Rhodi if you are looking for a blue star formula:

KCIO3  50 %
coppersulfate 25 %
sugar 25 %

Will this cause a reaction between the KClO3 and CuSO4?
or is it just sulfides that cause spontaneous combustion with chlorates?




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users