Jump to content


Photo

Arbor Press Modification


  • Please log in to reply
4 replies to this topic

#1 shadowpyro

shadowpyro

    Member

  • General Public Members
  • PipPip
  • 68 posts

Posted 25 September 2010 - 10:31 PM

Hey everyone,

Couldn't find anything on this in the forum, so I thought I'd start the thread.

Basically I was considering moving into pressing rockets rather than ramming, which would allow for whistles and whistle/BP hybrid drivers.
I realised the easiest way for smaller size engines < 1 lb, an arbor press would probably be best. Except that the clearance isn't big enough for most tooling, unless if it's a custom made special short tooling or something.
Basically, has anyone had any past experience in modifying arbor presses? (I know witchitta buggy did something with it, but only gave good details on changing a hydaulic press)

Cheers
There is no such thing as failure, either learn or succeed!

#2 dr thrust

dr thrust

    Pyro Forum Top Trump

  • General Public Members
  • PipPipPipPip
  • 1,408 posts

Posted 25 September 2010 - 10:58 PM

hi, its been done many times before, the basic jist is, drilling holes in the bottom of the arbor "foot", passing threaded rod though to a sturdy plate underneath, details here

Edited by chris m, 25 September 2010 - 11:02 PM.


#3 martyn

martyn

    Pyro Forum Regular

  • UKPS Members
  • 470 posts

Posted 25 September 2010 - 11:01 PM

Another pic here

#4 dr thrust

dr thrust

    Pyro Forum Top Trump

  • General Public Members
  • PipPipPipPip
  • 1,408 posts

Posted 25 September 2010 - 11:03 PM

beat me to it!, i was looking for that :)

#5 shadowpyro

shadowpyro

    Member

  • General Public Members
  • PipPip
  • 68 posts

Posted 26 September 2010 - 10:37 AM

woops! Cheers guys.
Delete thread if needed!
There is no such thing as failure, either learn or succeed!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users