Help
obviously I've been a little more careful since then.
This post has been edited by ElliotHC: 13 December 2011 - 10:46 PM
24mm OD Rocket Tubes?
#16
ElliotHC 
- Member
-
- Group: General Public Members
- Posts: 15
- Joined: 30-November 11
Posted 13 December 2011 - 10:43 PM
Of course I'm doing all this outside.. I've been around the block a bit and have been dabbling in this hobby since the mid to late 80's when I was 12 and had a home office visit! obviously I've been a little more careful since then.
obviously I've been a little more careful since then.
#17
ElliotHC
- Member
-
- Group: General Public Members
- Posts: 15
- Joined: 30-November 11
Posted 14 December 2011 - 07:28 PM
I have found a nice chromed steel tube with an OD of 18.9mm, with shrinkage I'd say that's got to be good for an ID of 18.5mm.
I've cut a 1m roll of brown parcel paper in to motor lengths so that the motors are the right length to start with, do I just paint on PVA as I wrap it around?
I've cut a 1m roll of brown parcel paper in to motor lengths so that the motors are the right length to start with, do I just paint on PVA as I wrap it around?
This post has been edited by ElliotHC: 14 December 2011 - 09:33 PM
